Free Download Latest 2014 Pass4sure&Lead2pass Juniper JN0-690 Dumps

Free Download Latest 2014 Pass4sure&Lead2pass Juniper JN0-690 Dumps

Vendor: Juniper
Exam Code: JN0-690
Exam Name: Junos Troubleshooting

QUESTION 1
Given the example shown below:
Emergency boot media > flash disk > _____
What is missing from the default boot list?

A.    LAN
B.    USB
C.    PCMCIA card
D.    hard disk

Answer: D

QUESTION 2
You are notified about a router reboot event.
Which command would be helpful in determining the reason for the last reboot?

A.    show chassis craft-interface
B.    show system reboot
C.    show chassis routing-engine
D.    show system snapshot

Answer: C

QUESTION 3
A technician has reported an alarm on your device running the Junos OS. You suspect it is due to the temperature in the rack. Which two commands will confirm your suspicion? (Choose two.)

A.    show chassis alarms
B.    show chassis firmware
C.    show chassis hardware
D.    show chassis environment

Answer: AD

QUESTION 4
Which process is responsible for managing interface devices on the system?

A.    chassis daemon
B.    device control daemon
C.    routing protocol process
D.    management daemon

Answer: B

QUESTION 5
You have been asked to troubleshoot an interface that is flapping.
Which three tools would you use to isolate the cause? (Choose three.)

A.    syslog messages
B.    ping utility
C.    loopback interface testing
D.    show interfaces
E.    PFE statistics

Answer: ACD

QUESTION 6
Which two commands help to identify traffic drops due to oversubscription? (Choose two.)

A.    show interfaces extensive
B.    show interfaces queue
C.    monitor interface traffic
D.    monitor traffic interface

Answer: AB

QUESTION 7
Which two features would be deployed to prevent DoS attacks? (Choose two.)

A.    Bidirectional Forward Detection (BFD)
B.    ARP policer
C.    loopback filter
D.    periodic packet management (PPM)

Answer: BC

QUESTION 8
Which three commands will provide details about CPU utilization on a line card? (Choose three.)

A.    show chassis fpc
B.    show chassis hardware
C.    request pfe execute target fpc1 command "show sched"
D.    request pfe execute target fpc1 command "show thread"
E.    request pfe execute target fpc1 command "show arp"

Answer: ACD

If you want to pass Juniper JN0-690 successfully, donot missing to read latest lead2pass Juniper JN0-690 dumps.
If you can master all lead2pass questions you will able to pass 100% guaranteed.

http://www.lead2pass.com/JN0-690.html

         

Author: admin